Douglas County Tree Service – Tree Removal – Top Tips

The cutting of trees can be very risky and even life-threatening. Removing a tree on your own is never suggested, unless it is a small one that you are sure you can manage safely. Otherwise, tree cutting can be left in the care of tree service contractors who are properly qualified and prepared. If you have a very small tree on your house, so it needs to be cut, you can do it yourself with the necessary resources, experience, and preparation.You may want to check out Douglas County Tree Service – Tree Removal for more.

Preparation For Tree Clearance

Proper training for small tree removal requires getting all the materials you require, as well as a thorough tree review. Check to see whether the tree leans one direction or the other and, in case it does not collapse the way you want it to fall, plan an escape path. Often, investigate whether there are any barriers, including cars, buildings, and other branches, in any path of the tree or not. When you are confident that there is ample safe clearance for the tree to collapse, so you can go on to retrieving your tools and instruments. It involves:

(Utility gloves, goggles, hard hat, steel toe boots, etc.) Safety Kit
Chainsaw Chainsaw
Hacksaw or Ax
Ladder Ladder
Rope Rope
Wedges Wedges
Kit for First Assistance
To Delete a Tree

You will begin the removal of the tree until you have all your equipment and supplies. To learn how sturdy or hollow the tree is, first use your ax to bang on the bark a few times, and in a few different locations. It would be better to find a less compact region to cut. First, schedule which side of the tree you intend to cut. Look to see where the tree bends instinctively; it is easier to cut a tree in the direction it naturally wishes to tip in. Make careful that the area where the tree falls is straight, so that when it falls, the tree does not roll or bounce.

Create a horizontal cut into the tree at hip height and around 1/3rd. On the side of the tree where you expect it to land, do this. If you want the tree to collapse to the right, on the same foot, you have to cut it so that it falls inward, into the cut. Your tree is going to collapse perpendicular to the horizontal cut. A wedge through the tree should be produced with the second cut. So, make the second cut from the original cut at an angle. It was meant to look like a lemon slice.

Your third cut is considered a back cut, and the wedge cut can be achieved on the opposite side. This cut would make the tree on the side of your wedge cut tip down. Make it about 1.5 inches, and as thick as possible, above the wedge cut. You should also use a wedge to keep the chainsaw from settling on the wood. As needed, add more wedges before the tree starts to collapse. Fly, then! But as it falls, do not turn your back on the tree.